Many times not all graphics are stored by the WaybackMachine, so if there are graphics missing from the following VFAQ, please don't email me about them (unless you are emailing me to tell me you have a copy of the missing graphic you can send me).

If you know the original author of this VFAQ, and have their contact info, please have them email me if they have any missing info to add, have the VFAQ at another site I could not find, or wish to have it removed from my site.

Apexi Turbo Timer Install into a 2003 Evolution VIII

This install of a Apexi turbo timer is fairly straightforward and can be installed by any average shadetree mechanic. Tools: Wire Strippers or scissors Pliers Phillips screwdriver 10 mm socket and handle Before you begin the install it is a good idea to read through all the applicable information and directions that come with the Turbo Timer itself. We will be using a HKS Turbo Timer Harness for this install as to not tamper with the stock wiring. The first step or the install is to disconnect the negative terminal from the battery. This ensures that there is no possibility of accidentally shorting any electrical devices. Locate the battery in the engine compartment Then take a look inside your cabin and move your driver seat to its furthest rear position. Start removing the bolts holding the center steering column together. Then remove your ashtray / change tray, make sure not to lose the spare fuse puller or spare fuses mounted to the back of this unit. Then remove the 10mm bolt behind the tray Remove the bolts holding the lower cover onto your dash. Unplug the Evolution dash dimmer switches and interior controls and take the panel completely off to allow better access to the ignition system. Now, take the Evolution center steering column assembly apart by removing the 3 phillips screws. When you have the Evolution center steering column assembly apart, then remove the Evolution ignition plug, marked in this picture Now locate your Turbo Timer Harness, and although we are installing an Apex Turbo Timer, we will be using a HKS harness. Most harness, regardless of the turbo timer itself will work as long as you have the vehicle application correct. The Evolution harness is the same as the 2nd generation Eclipse harnesses. Plug the male side of the harness into your stock ignition module, then plug the stock Evolution side into the female side. Bolt everything back up and you now have a turbo timer in your Mitsubishi Evolution!! Enjoy!

Home

Pro Street Online, Inc. Copyright 2002-2003, All rights reserved.